Foxconn Destroyer User Manual

Page 43

► ACPI Function

This item is used to enable or disable the ACPI function.

► ACPI Suspend Type

This item is used to set the energy saving mode of the ACPI function. When you select “S1

(POS)” mode, the power is always on and computer can be resumed at any time. When

you select “S3 (STR)” mode, the power will be down after a period of time. The status of the

computer before it entering STR will be saved in memory, and the computer can quickly return

to previous state when the STR function wakes.

► Power Button

This item is used to set the power down method. This function is only valid for systems using
an ATX power supply. When set to [Delay 4 Sec.], the power button will put the system in
Suspend mode if you push the power button in less than 4 Second then release. If set to
[Instant-Off], the PC powers off immediately when the power button is pressed.

► PWRON After PWR-Fail

This item is used to set which state the PC will take with when it resumes after an AC power

loss.

► HPET Support

HPET stands for High Precision Even Timer. If you have the HPET disabled, then windows

does not have access to it and therefore falls back to less accurate timing methods. This item

is used to enable or disable the HPET Support.

** Power Management Events **

► Resume by PCI/PCIE PME

This item is used to enable/disable PCI/PCIE PME# event to generate a wake up. PME# is a

signal which can be triggered from a PCI/PCIE card. It represents Power Management Event.

► USB KB/MS Resume from S3

This item is used to set the system to be waken up by USB keyboard or mouse when it is stay-

ing at S3 (Suspend to RAM) state.

► Resume by Alarm

This item is used to set the timing of the start-up function. In order to use this function, the

start-up password function must be disabled. Also, the PC power source must not be turned

off.

► Date of Month Alarm

When "Resume by Alarm" is set to “Enabled”, this item can be modified. It is used to set the
timing for the start-up date.

► Time (hh:mm:ss) Alarm

When "Resume by Alarm" is set to “Enabled”, this item can be modified. It is used to set the
timing for the start-up time.

► Power On by Button

This feature is valid only when "PS/2 KB Resume from S3" is set to Password, Hot key or

Keyboard 98. Enabling this feature allows normal powering on by pressing power button, while

disabling it then pressing power button has no function.

► PS/2 KB Resume from S3

This item allows you to use the PS/2 keyboard to wake up the system from S3 mode. This

feature requires an ATX power supply. The setting values: [Disabled]; [Password]; [Hot KEY];

[Any KEY], and [Keyboard 98].