Formax 6204 Series - Manual (Page 67)

Clean the exit sensors
To clean the exit sensors:
1. Rotate a slightly moistened cotton swab in the lower hole, to clean the lower exit
sensor.
2. Rotate a slightly moistened cotton swab in the upper hole, to clean the upper exit
sensor.
3. Calibrate the photocells (see Resetting photocells on page 62).
Resetting Photocells
To calibrate all photocells:
1. In the Test menu, press the [Reset photocells] button. The Calibrate photocells menu
appears.
2. Remove all documents and envelopes and close all covers before starting the
calibration.
3. In the Calibrate photocells menu, press the [Cal.] button.
When the calibration is finished, the system returns to the Calibrate photocells menu.
62
| Page 62 | apr-16-2012 13:09 |
8
English