Formax 6204 Series - Manual (Page 66)

Clean and replace brushes
When dirty or saturated, clean the brushes of the envelope sealing or replace them as
follows:
1. Moisten the new brushes in water.
2. Remove the brushes one by one by pulling them down from the brush holder.
3. Replace the brushes. Make sure that the studs on the brushes are fitted in the
corresponding holes in the brush holder.
Clean the sensors on the envelope or document path
When the display warns about dusty sensors in the envelope or document path, clean them
as follows:
1. Open side cover A.
2. Place bellows B in the upper air plug C and firmly squeeze a few times to blow the
dust from the document path sensor.
3. Place the bellows in the lower air plug and firmly squeeze a few times to blow the
dust from the envelope path sensor.
4. Calibrate the photocells (see Resetting photocells on page 62).
8
English
61
| Page 61 | apr-16-2012 13:09 |