ETA Cabero 4 v 1 - Manual (Page 35)

GB
35 / 69
Electronic revolutions regulation (A2)
It enables setting optimum revolutions for the selected chopping, blending, mixing,
beating, cutting and grating adapter. By turning the regulator from - (MIN) to + (MAX)
you can continuously change the speed of the motor revolutions (Fig. 2).
The set speed value (1 to 8) is shown at display A3 (not for type ETA 4016, ETA 5016
a ETA 7016).
According to the method of use of the accessories we recommend the following
speed setting:
Blending adapter 1 – 8; (min - max)
Beating adapter 3 – 8; (1/3 - max)
Sickle-shape knives 1 – 8; (min - max)
Graters 1 – 8 ; (min - max)
Attachment for mashing potatoes 1 – 8; (min - max)
Chopping container Express 1; (min)
Mounting and removing drive unit (A)
Insert the drive unit by slight pushing into the connecting hole of the respective adapter
(Fig. 3) till the blocking snaps in (you will hear snapping noise). Remove the drive by
pushing both locking buttons A5 and remove the unit by slight pulling.
Mounting and removal of beating adapter (C, C1)
Push beating whisk C slightly to gear C1 to the maximum position (Fig. 4), (you will hear
snapping sound). Remove the beating whisk from the gear in the opposite direction.
Mounting and removal of beating adapter (D, D1)
Push beating whisk shafts D slightly to gear D1 to the maximum position (Fig. 5), (you
will hear a snapping sound). Remove the whisks from the gear in the opposite direction.
Mounting and removal of lid (F3, G3)
Put the lid onto the respective container F or G so that the lugs on its edge snap into
the moulded holes in the container and secure the lid by clockwise movement to the
maximum position (Fig. 7). You can remove the lid from the container in the opposite
direction.
Mounting and removal of lid (H3)
Put the lid on multi-purpose container H so that the lugs on its edge snap into the
moulded holes in the container. Bend interlock H2 by slight pushing and turn the lid
in the clockwise direction to the maximum position (Fig. 8). Then release the interlock.
Now the lid is secured in the right position. You can remove the lid from the container
in the opposite direction.
Mounting and removal of sickle-shaped knife (F2, G2, H8)
Hold knife at the upper plastic part, remove the protective cover and put it in the
container so that it is inserted on the shaft with its central hole and give it a turn to lock
into place (Fig. 9). You can remove the knife from the container in the opposite direction.