DNF Controls DMAT-DL - Manual (Page 4)

4 DMAT, for DoReMi Labs Protocol
Getting Started . . .
3. INSTALLATION
1.
Plug one end of a 9 conductor, RS422 serial cable in to the 9-pin connector on the
rear of the ST300. Plug the other end of the cable into the 9-pin remote connector
on the Video Server.
2. Plug the POWER SUPPLY into a wall outlet, 90 VAC TO 240 VAC.
3. Select REMOTE mode on the VTR's front panel.
4. Check the SETUP MENU prior to using the Slow Motion Controller to confirm
proper Record mode, SLO-MO speed range and other User settable modes.
Installation is complete.
Connection Diagram
LCD
D ISPLAY
During normal operation, the top row of the display shows the selected time mode and
current time location of the VTR.
For example: TM 01:12:09:23
Time Modes - TM= Tape Timer TC= LTC VT= VITC
The currently selected SLO-MO speed is displayed on the far right side of the top
row.
The bottom row of the display shows the current Cue Point number and its contents.