DNF Controls DMAT-DL - Manual (Page 14)

14 DMAT, for DoReMi Labs Protocol
RECEIVE CUELIST FUNCTION.
The RECEIVE CUELIST function allows you to receive your list of Cue Points from a
PC or from another ST300. Transfer to a PC requires OpSuite 3.0 software, which runs
on a Windows-based computer. Contact DNF Controls for more information.
To Receive Cue Points from the ST300:
1. Connect the VTR4 connector on the back of the ST300 from the VTR4 connector
of the transmitting ST300 using RS422 9-pin cable with TX and RX lines crossed.
(A “Turnaround” Cable)
2. Press [MENU].
3. Scroll the wheel until “Receive CUE List? YES=Enter, Exit=ESC” is displayed.
4. Press [ENTER] from start receiving.
The Display shows “Waiting to receive” on the first line.
5. When the Transmitter is ready, transfer starts automatically.
The Display now shows “Receiving cuelist”.
6. After the transfer is over the display shows “Done-Success! Press any key…”
7. Press any key. The display shows “Receive cuelist?” message.
8. Press [ESC] to exit the MENU mode.
To Receive Cue Points from the PC:
1. Connect the VTR4 connector on the back of the ST300 to one of the COM ports on
the PC using RS422 to RS232 adapter
2. Repeat steps 2-8 of the RECIVE CUE POINTS from the ST300 section.