DNF Controls DMAT-DL - Manual (Page 10)

10 DMAT, for DoReMi Labs Protocol
5. OPERATION
Select the desired transport function by pressing the appropriate switch on the SLOW
MOTION CONTROLLER.
The Real-Time Status Indicators will light to indicate the VTR's current tape transport
mode.
For example: Pressing [PLAY] will put the VTR into the PLAY mode.
The PLAY Status Indicator will turn on when the VTR is in PLAY mode.
Press [RECORD] OR [RECORD] + [PLAY] to put the VTR into
Record mode. (See SETUP MENU)
NOTE: The VTR will not go into Record mode if "Record Inhibit"
is enabled on the VTR or tape cassette.
Check SETUP MENU prior to using the SLOW MOTION
CONTROLLER to confirm proper Record mode and other
User settable modes.
A. DMAT O PERATION
SIMULTANEOUS RECORD/PLAYBACK SETUP.
1. Connect RS422-1 connector of the V1 unit to the VTR1 connector on the back of the
ST300. VTR1 is a recorder.
2. Connect RS422-2 connector of the V1 unit to the VTR2 connector on the back of the
ST300. VTR2 is a player.
3. On the back of the V1 unit:
The Incoming video comes through VIDEO IN/1 connector.
Connect the VIDEO OUT/1 connector to VIDEO IN/2 connector.
The incoming Time Code comes through Time Code IN/1 connector.
Connect the Time Code OUT/1 connector to Time Code IN/2 connector.
4. On the ST300:
Press VTR [1].
Press [MENU].
Press <,> until DOREMI MENU is displayed.
Press Softkey [YES] to enter DOREMI MENU.
Turn the Wheel until the display shows “Time Mode”
Press Softkey [CHG] to select Time Code.
Press [ESC] to exit the menu mode.
5. On the ST300:
Press VTR [2].
Press [MENU].
Press <,> until DOREMI MENU is displayed.
Press Softkey [YES] to enter DOREMI MENU.
Turn the Wheel until the display shows “Time Mode”.
Press Softkey [CHG] to select Time Code.