DNF Controls DMAT-DL - Manual (Page 15)

15 DMAT, for DoReMi Labs Protocol
Reference . . .
7. FUNCTION TABLE
Function Key Press Description
EE On/Off [EE] Toggle PB/EE mode on/off. Status indicator is on
when PB/EE mode is on. NOTE: in PB/EE mode, the
unit goes into EE mode any time it is in STOP mode.
ENTER TIME [ENTER TIME] To manually entered timecode numbers into the
currently displayed Cue Point. Enter the desired
timecode number using the numeric keypad. Press
[ENTER] to save your entry OR [ESC] to exit
without saving.
To enter a GOTO location without altering the
contents of the Cue Point, enter the desired timecode
number using the numeric keypad. Press [GOTO] to
search to the entered time. Press [ESC] to exit
without searching.
FREEZE
ENABLE
[FREEZE] Toggles the Freeze on/off. When the light is ON, the
Freeze is enabled. When the light is OFF, the freeze
is disabled. NOTE: this is NOT a REC OUT freeze,
it IS a user defined Freeze.
FREEZE
[SHIFT] + [FREEZE]
(Active in SLO-MO
only). To enter or mark the Freeze time press [SHIFT] +
[FREEZE]. The display shows the current freeze
time. You can enter the Freeze time using the
numeric keypad or MARK the current time into the
Freeze time by pressing [MARK]
FREEZE ON
LAST GOOD
VIDEO
Active in SLO-MO
only. In SLO-MO mode, STILL frame the VTR when the
current timecode is within 6 frames of the last Record
Out point (memorized automatically upon exiting
Record mode). Enable, disable or clear FREEZE
point from SETUP MENU (see MENU).
GOTO CUE or
ENTERED
TIME [GOTO] Search the VTR to the contents of the currently
displayed Cue Point. If ENTER TIME is active (LED
is on), search the VTR to the entered time.
To enter a GOTO location without altering the
contents of the Cue Point - Press [ENTER TIME].
Enter the desired timecode number using the numeric
keypad. Press [GOTO] to search to the entered time.
Press [ESC] to exit without searching.