DNF Controls 2MCE-24P - Manual (Page 8)

8 2MCE-24P, Two Machine, Cuts Only Editor
4. OPERATION
a. TRIM AN IN/OUT POINT
1) Press [ TRIM+ ] or [ TRIM –] .
The display will prompt “Enter Time, Select IN/OUT .”
2) Enter the amount of trim using the numeric keypad.
The top row of the display will show the entered amount.
3) Press [ IN ] to trim the IN Point.
Press [ OUT ] to trim the OUT Point.
The trimmed time will be displayed on the bottom row of the display.
b. CLEAR AN OUT POINT
Press
[ CLR OUT ] to clear the OUT point.
The OUT key indicator will turn off.
The OUT Point on Recorder and Player will be cleared to 00:00:00:00.
c. GOTO IN/OUT POINTS
1) Press
[GOTO]. The GOTO key Indicator will turn on.
2)
The display will prompt for IN or OUT.
3) Press
[IN] to goto the IN Point.
Press [OUT] to goto the OUT Point.
OR
Press [ESC] to exit without searching.
d. CRASH RECORD
NOTE: Check the Record option in the Setup Menu. It should be set to Crash Record.
1)
Select the Recorder.
2) Press
[SHIFT] + [RECORD] if the option in the Setup Menu is set to Rec only.
Press [RECORD] + [PLAY] if the option in the Setup Menu is set to Rec +
Play.
The record VTR will begin recording immediately.
There is no preroll in the Crash Record mode.
The RECORD key indicator will turn on.
3) Press
[STOP] to end recording. RECORD indicator turns off.