G. set the record mode, H. set the video standard, I. set preroll value – DNF Controls 2MCE-24P User Manual
Page 6
6 2MCE-24P, Two Machine, Cuts Only Editor
f.
SET THE RECORD DELAY
1)
Press
[
MENU
]
.
The MENU key indicator will turn on.
2)
Turn
the
wheel until
“RECORD DELAY=
”
is displayed.
3)
Enter Record Command latency (delay) time in frames
using the numeric
keypad
.
(Typical value for SONY BVW75 is 3 frames
.
)
4)
Press
[
ESC
]
to exit the SETUP MENU.
The MENU key indicator will turn off.
g.
SET THE RECORD MODE
1)
Press
[
MENU
]
.
The MENU key indicator will turn on.
Turn the wheel until
“REC
: =”
is displayed.
2)
Press
[MENU]
to toggle between LOCKOUT, ASSEMBLE, CRASH
and
INSERT record modes.
3)
In INSERT mode, press the “SOFTKEYS” to select Video, Audio1, Audio2,
Audio3 or Audio4.
NOTE: The 5 “SOFTKEYS” are located just below the Display.
4)
Press
[
ESC
]
to exit the setup menu.
Indicator will turn off.
h.
SET THE VIDEO STANDARD
1)
Press [MENU]. The menu indicator will turn ON.
2)
Turn the wheel until “Video Standard:” is displayed.
3)
Press the softkey (a key underneath the desired standard: 24P, NTSC or PAL) to
select a video standard to perform edits in.
4)
Press [ESC] to exit the setup menu.
i.
SET PREROLL VALUE
1.
Press
[
SHIFT
]
+
[
PREROLL
]
.
The display will show the current Preroll
Value.
2. E
nter the desired Preroll Value
using the numeric keypad
. The display will
show the entered value.
3.
Press
[
PREROLL
]
to save the current value and exi
t.
OR
P
ress
[
ESC
]
to exit without saving.
Installation
is
complete.