DNF Controls 2MCE-24P - Manual (Page 5)

5 2MCE-24P, Two Machine, Cuts Only Editor
3. INSTALLATION
a. ST300-S/SM, VTR/DDR CONTROLLER
1)
Plug one end of a 9-conductor, RS422 serial cable into the 9-pin connector
(VTR1, VTR2, VTR3 or VTR4) on the rear of the ST300. Plug the other end of
the cable into the 9-pin remote connector on the Video Server.
2)
Connect the +5, +12, -12 VDC POWER SUPPLY into the POWER connector
on the rear of the ST300. Plug the Power Supply into a wall outlet, 90 VAC to
240 VAC.
3)
Check SETUP MENU prior to using the ST300 to confirm proper Record mode
and other User settable modes.
b. SELECT RECORDER
Press [SHIFT] + [VTR1], [SHIFT] + [VTR2], [SHIFT] + [VTR3], or [SHIFT] +
[VTR4] to select the RECORDER. The VTR’s LED will flash.
c. SELECT PLAYER
Press [VTR1], [VTR2], [VTR3] or [VTR4] to select the PLAYER. The VTR’s LED
will turn on.
NOTE: Selecting a PLAYER VTR will automatically put the RECORDER VTR into
EE mode. The selected PLAYER VTR indicator will turn on and remains on when the
RECORDER is selected.
d. REFERENCE VIDEO INPUT
Connect Black Video or the Tri-level Sync (for 24P editor) to the Reference Video BNC
on the rear of the 2MCE.
NOTE -
The ST300 will allow edits without sync.
e. SET THE VTR’S COLOR FRAME MODE
1) Set the color frame on the R ECORD DECK to: ON
2) Set the color frame on the P LAYBACK to: OFF
3)
Set the VTRs Capstan Lock. Set Capstan Lock on the Recorder to “2FD.”