DNF Controls 2MCE-24P - Manual (Page 14)

14 2MCE-24P, Two Machine, Cuts Only Editor
Reference . . .
5. SETUP MENU
‰ Press [MENU]. The MENU indicator will turn on. Turn the Wheel to select item to change.
‰ Press [ESC] at anytime to exit SETUP MENU. The MENU indicator will turn off.
MENU MODES (Turning Wheel clockwise)
RECORD MODE Press [MENU] to select the desired record mode: Lockout, Crash (Full).
Only in INSERT mode: Press the associated Softkey, located below the
display, to toggle Video(V), Audio1(A1), Audio2(A2), Audio3(A3),
Audio4(A4) on/off.
SLOMO SPEED
RANGE
Press [MENU] to select the desired speed range:
-100
Î +200 or 0 Î +200
SLOMO PRESET Press [MENU] to select the desired mode: UPDATE or STATIC
UPDATE - When exiting OFFSPEED mode, the last used speed is saved in
the
Preset Speed register.
STATIC - The Preset Speed register is NOT updated when the wheel is
turned. Upon entering OFFSPEED mode, the slomo speed is always restored
to the preset value set by [SHIFT] + [SLOMO].
MAX WIND SPEED Press [MENU] to select the desired maximum wind speed.
WIND MODE Press [MENU] to select the desired wind mode, LATCH or HOLD.
LATCH - Fast wind is initiated and maintained with a momentary key press.
HOLD - Fast wind is initiated and maintained only while key is pressed.
Upon releasing key, wind mode terminates.
VIDEO STANDARD Press a Softkey to select the desired video standard – PAL, NTSC or 24P.
RECORD Press Softkey to select single button or 2-button record.
RECORD = [REC] Only OR RECORD = [REC] + [PLAY]
DISPLAY SOFTWARE
VERSION
The version number for the currently installed software is displayed.
CLEAR MEMORY Press [DEL] to clear the controller’s internal memory. Press [ESC] to exit
without clearing memory.
SET FACTORY
DEFAULTS
Press [DEL] to initialize the controller to factory defaults.
Press [ESC] to exit without initializing controller to factory defaults.