D-Link DCS-5300 - Manual (Page 67)

67
If you enable proxy server and enable IP restriction, the listed IP
addresses will not use the proxy.
Connecting to the DCS-5300
Check here to enable proxy.
Set the proxy
Add an IP address
Delete an IP address
Click OK
Using IP surveillance Software (continued)
Check here to enable filter
Enter IP address to add
Once you connect to the DCS-5300, you can drag and drop a camera into the
video area.
In the channel area, if you do not set up the camera, the color of the camera
number will be gray. Once you set up the camera, the color of the camera
number will turn to blue. You can drag and drop the camera into the video
area, and apply other features if you have the privileges by logging on as an
administrator (admin).
There is a unique light signal above each camera’s number. This indicates the
status of the camera:
Off Camera is not connected.
Green The green light means the camera is connected.
Red The red light indicates the camera is both connected and in
recording mode.
Blink If motion detection is enabled, an alert occurs and the light will
blink.
–
–
–
–