D-Link DCS-5300 - Manual (Page 25)

25
Using & Configuring the DCS-5300 with a
NAT Router (continued)
These are the port settings for
your camera.They can be
changed if needed.
Ports that are used by the DCS-5300
Router Set-Up and Installation
The following steps generally apply to any router that you have on your network.
The D-Link DI-614+ is used as an example to clarify the configuration process.
Configure the initial settings of the DI-614+ by following the steps outlined in the
DI-614+ Quick Installation Guide.
Access Your Router on Your Web Browser
If you have cable or DSL service, you will most likely have a dynamically assigned
WAN IP Address. ‘Dynamic’ means that your router’s IP address can change
from time to time depending on your ISP. A dynamic WAN IP Address identifies
your router on the public network and allows it to access the Internet. To find
out what your router’s WAN IP Address is, go to the Status menu on your router
and locate the WAN information for your router. As shown on the next page the
WAN IP Address will be listed. This will be the address that you will need to
type in your web browser to view your camera over the Internet.