D-Link DCS-5300 - Manual (Page 48)

48
Enable IR Control - Click this to enable the DCS-5300 to be controlled
by the included remote.
Configuration > Advanced >Camera Control (Continued)
Current Position -
Enter a name for the position at which you would
like to preset the DCS-5300. Click Add to add the
new preset position to the Preset Locations list.
Preset Position - Using the pull down menu, you can delete a preset
position by selecting it and clicking Delete.
Dwelling Time - Set the value of time that the camera will remain on
each preset position before moving to the next. The
dwelling time can be set between 1and 9,999
seconds.
Patrol Selection -
To use the Auto Patrol feature, select the desired
presetpositions from the Preset Locations list and
add them to the Selected Locations list by clicking
Select
. You can then select the order in which the
camera will patrol through the preset locations
by selecting a location and clicking UP or DN.
Click Remove to remove a location from the list.
Click Apply to make
changes effective
Using the DCS-5300 with an Internet browser
(continued)