D-Link DCS-5300 - Manual (Page 10)

10
Software Installation
After you have successfully completed the hardware installation of the
DCS-5300 Internet Camera, it is necessary to install software to configure and
operate the camera. The first step is to run the IP Installer program on the CD.
IP Installer allows you to use the Internet Camera with your Internet browser.
With the IP Installer program you can enter settings that permit the camera to
access the Internet directly or through your Ethernet network.
After the IP Installer software program is completed, you will have an operating
and controllable Internet Camera. From your Internet Explorer Web browser
you will be able to access the video and sound from the Internet camera. The
camera has a built-in Web server. This Web server will allow the camera to
access the Internet without being attached to a computer and permits users to
view the video and audio remotely.
After running the IP Installer, you will be able to operate the DCS-5300 and
view the camera remotely through Internet Explorer 5.x and above.
However it is necessary to install the IP surveillance software from the enclosed
CD to create a truly powerful monitoring and surveillance system. The following
section will show in detail the installation of the IP Installer and the IP
surveillance software.
Installing the IP Installer program
Insert the CD that is included with the DCS-5300 Internet Camera . The
DCS-5300 installation menu will start up automatically from the CD. If the CD
does not startup automatically (the Windows operating system may turn this
function off), access the CD from Windows and click on the autorun.exe program
to access the installation menu shown below:
Click IP Installer