Devolo MicroLink dLAN Audio - Manual (Page 36)

devolo MicroLink dLAN software
|
| devolo MicroLink dLAN Audio |
36
EN
4.5.6 Configuring the TCP/IP settings
If you are using static IP addresses on your network, you can also use the
HTML configuration interface to assign a certain IP address to the MicroLink
dLAN Audio adapters.
On the 'Configuration' page, click the 'Configure TCP/IP settings' entry. In the
dialog which follows, you can set the IP address, the subnet mask and the
standard gateway. To do so, enable the 'Use the following TCP/IP settings'
option to switch off automatic assignment of IP addresses.
Please note the IP address you have assigned to the MicroLink dLAN Audio
adapter. If you ever change the IP addresses on your network, you can use
this address to access the MicroLink dLAN Audio adapter without having to
restore the factory default settings. For one PC on the network, set a static IP
address from the address range of the MicroLink dLAN Audio adapter, and
then change the TCP/IP settings of the unit according to your new network
configuration.
4.5.7 Updating the firmware
We continue to provide support with software and firmware updates for your
device after you have purchased the MicroLink dLAN Audio adapter. After
downloading new firmware from the Internet, you can use the HTML config-