Delta Dore RF 642 - Manual (Page 8)

- 15 -
The simple lighting mode can be associated with a
TYXAL detector (opening, movement, technical fault,
etc.).
On the receiver, press the button until the LED flashes
(~3 seconds).
On the detector, press the Test key (emits a beep).
Check that the receiver’s LED is no longer flashing.
The detector is associated with the receiver.
ON OFF
Lights switch off
90 seconds after
the last detection Lights switch on
following detection
ON OFF
Lights switch off at
the end of detection Lights switch on
following detection
The receiver can record up to a maximum of 8
associations (buttons, transmitters, etc.).
Simple lighting mode with an associated
TYXIA transmitter
- 14 -
Associate the button with the
receiver
On the receiver, set the appliance to the required sta-
tus (e.g. light off), then press the button until the LED
flashes (~3 seconds). You now have two options.
Slow flashing: simple lighting mode
Quick flashing: pulse mode.
Press the receiver button to switch from one rate of
flashing to the other.
Select the slow flashing option.
On the transmitter, press and hold the button
down for approximately 5 seconds.
The button will light up, go out then light up again.
Release.
Check that the receiver’s LED is no longer flashing.
The transmitter button is associated with the
receiver.
One button (scenario) can control different
receivers simultaneously (roller shutters, dimmer, sim-
ple lighting, etc.).
Simple lighting mode with an associated
TYXAL detector