Daktronics DF-1030 - Manual (Page 8)

Figure 1 illustrates the Daktronics drawing label. The drawing number is located in the
lower-right corner of the drawing. Listing the last set of digits and the letter preceding them
identifies drawings in the manual. In the example the drawing would be referred to as
Drawing A-181218. Reference drawings are inserted in Appendix A.
Figure 1: Daktronics Drawing Label
All references to drawing numbers, appendices, figures, or other manuals are presented in
bold typeface, as shown below.
“Refer to Drawing A-181218 in Appendix A for the display dimensions.”
Additionally, any drawings referenced within a particular subsection are listed at the
beginning of that subsection in the following manner:
Reference Drawing:
Mechanical Specs, DF-1020-13, G3 ...................................... Drawing A-181220
The model numbers of a Daktronics display can be found on the ID label on the display. The
label will be similar to the one shown in Figure 2. When calling Daktronics Customer
Service, please have this information available to ensure that your request is serviced as
quickly as possible.
Figure 2: Display Identification Label
Daktronics displays are built for long life and require little maintenance. However, from time
to time, certain display components may need replacing. The Replacement Parts List in
Section 4 provides the names and numbers of components that may need to be ordered during
the life of the display. Most display components have a white label that lists the part number.
The component part number is in the following format: 0P-____-____ (component) or 0A-
____-____ (multi-component assembly).
Following the Replacement Parts List is an explanation of Daktronics Exchange and
Repair and Return Programs in Section 4.7. Refer to these instructions if any display
component needs replacement of repair.
1-2 Introduction