Daktronics DF-1030 - Manual (Page 47)

Display Operation 5-3
CHANGE FUNCTION?
PRESS SET FUNCT
This message appears next on the screen.
If “RATE DISPLAY” was shown on the bottom
line of the LCD during startup, do nothing. The
controller will automatically default to previous
Rate Display settings. (The controller will
remember the last function used, so you
should only have to do this with a new
controller or when switching between
DataMaster displays.)
If a function other than “RATE DISPLAY” was
shown on the bottom line of the LCD during
startup, press the < SET FUNCTION > key while
the second LCD prompt is displayed.
You only have 1 or 2 seconds to push it. If you
miss it, unplug the power to the DM-100 and
try again.
SELECT FUNCTION
RATE DISPLAY
↓↑
Press the arrow up or down keys < ↑↓ > until
the rate display option is shown. Press the
< ENTER > key to accept.
Note: The actual Rate Price values will not be displayed on the DataMaster 100
LCD screen because these values are kept in the display itself.
Menu Items
Pressing the < MENU > key accesses the following settings:
1. Price Line 1
2. Price Line 2
3. Price Line 3
4. Price Line 4
5. Price Line 5
6. LED Test?
7. Display Option
8. Modem Settings
9. Display Status
10. Set Time 12HR
Use Menu items 1-5 to edit the price on each line of the display. Lines are typically
numbered top to bottom with 1 being the top of the display. For further details, refer
to Modifying Price Line Settings discussed previously in this section.