Daktronics DF-1030 - Manual (Page 34)

LED Driver Jack Functions
Jack Number Function
J1-J4 (4-column)
J1-J8 (8-column)
J1-J16 (16-column) Digits Output
J17
Signal/Power Input
J20 Protocol-5 Location
J23 12 VDC Power Out
J24 Modem
TB1 CAN (photo sensor)
J19 Address Plug (older drivers only)
J18, J21, J22, J25, J26, J27,
J28
Jacks not used in this application
The display line controlled by the driver is set with a DIP-switch that is set at the
factory before shipment. (Note: Some older drivers use a 12-pin address plug
inserted in J19). All DataMaster displays ship with the “Line 1” address already set.
Replacing a Signal Surge Board
Reference Drawings:
Enclosure Driver, 4 Column Reference....................... Drawing A-183775
Electrical Specification Drawings .............................Refer to Appendix A
Mechanical Specification Drawings ..........................Refer to Appendix A
The surge board is mounted inside the display enclosure and behind a digit, but
location and mounting varies by model. Refer to the Electrical and Mechanical
Specification Drawing for the location of your surge board. All displays are
front-accessible.
1. Open the digit panel or display face panel as described in Section 4.2.
2. Remove the cover from the driver
enclosure.
4-6 Maintenance and
Troubleshooting
3. Disconnect all connectors from the
surge board. Release each connector by
squeezing together the locking tabs as
you pull the connector free.
Note: When reconnecting, remember
that these are keyed connectors and will
attach in one way only. Do not attempt
to force the connections.
4. Remove the nuts securing the driver to
the inside of the enclosure.
5. Carefully lift the surge board from the
display and place it on a clean, flat surface.
Figure 19: Signal Surge Suppression Board
6. Follow the steps in reverse order to attach a new driver.