Q-See QSC26408 User Manual
Page 91
User Manual for Commercial Series Net DVR
Page
91
Total
121
Step 3: Establish the dialup connection
Select the Modem connected with PC just like the dialup network connection, input the
telephone number connected with DVR’s modem. Input the username, password. They must be
the same as in DVR PPP setup.
Step 4: During the dialup connection, it will give the message: “verification of username and
password”, after successfull verification; the message will be given: “on process of register in PC”.
The process is the same as a common dialup connection.
Step 5: After successful dialup, network will designate the “remote IP” address to PC, e.g.
the set 192.1.0.1. User can Ping-link the assigned IP address through Ping command, and can
Ping-link DVR. Please refer to the following picture.
Step 6: You can preview the image of 192.1.0.2 by using client-end software.