Q-See QSC26408 - Manual (Page 20)

User Manual for Commercial Series Net DVR
Page
20 Total 121
13 PTZ Same PTZ key of front panel.
14 ESC Same as ESC key of front panel.
15 Reserved
16 F1 Same as
【F1】key of front panel.
17 Lens control
IRIS, FOCUS ZOOM for lens control
of PTZ camera.
18 F2 Same as
【F2】key of front panel.
Loading the batteries into the Remote Control
1. Remove the battery cover.
2. Insert the battery. Please make sure the poles (+ and -) are correctly positioned.
3. Replace the battery cover.
Start to use the Remote Control
Press
【DEV】key, input the DVR device ID (default is “88”, can be changed in “Display”
menu) and then press
【ENTER】key. If the “STATUS” lamp of DVR front panel turns to green, it
means you can use IR controller to operate this DVR.
Stop using the Remote Control
When remote control status is on, press
【DEV】key again, the “STATUS” lamp will be turned
off, then the remote control can not control this DVR.
Switch the DVR off
When remote control status is on, press
【POWER】key for several seconds, the DVR will be
powered off.
When the Remote Control can not work normally
 Check batteries pole positions.
 Check the remaining charge in the batteries.
 Check to see the remote control sensor is covered.
If the problem is still exists, please contact administrator.