Contemporary Control Systems Compact Managed Switches Software Manual for Web Browser - Manual (Page 64)

TD020851-0MG
64
5.2.1.6 ‘UDP’ group 1.3.6.1.2.1.7
5.2.1.6.1 The UDP Listener Table — ‘udpTable’ 1.3.6.1.2.1.7.5
When an IP address is used as input, its format should be 4 decimal fields.
oid = “1.3.6.1.2.1.7.5.1.1.< udpLocalAddress >.< udpLocalPort >”
udpLocalAddress: The local IP address for this UDP listener.
Access: read-only
oid = “1.3.6.1.2.1.7.5.1.2..”
udpLocalPort: The local port number for this UDP listener.
Access: read-only
5.2.1.7 ‘Transmission’ group 1.3.6.1.2.1.10
Based on the transmission media underlying each interface on a system, the corresponding
portion of the Transmission group is mandatory for that system.
In this switch all interfaces are Ethernet-based — hence, the Ethernet-like interface is used.
5.2.1.8 ‘SNMP’ group 1.3.6.1.2.1.11
oid = “1.3.6.1.2.1.11.1.0”
snmpInPkts: The total number of Messages delivered to the SNMP switch from the
transport service
Access: read-only
oid = “1.3.6.1.2.1.11.2.0”
snmpOutPkts: The total number of SNMP Messages which were passed from the
SNMP protocol switch to the transport service
Access: read-only
oid = “1.3.6.1.2.1.11.3.0”
snmpInBadVersions: The total number of SNMP Messages which were delivered to
the SNMP protocol switch and were for an unsupported SNMP version
Access: read-only
oid = “1.3.6.1.2.1.11.4.0”
snmpInBadCommunityNames: The total number of SNMP Messages delivered to the
SNMP protocol switch that used an SNMP community name not known to said switch
Access: read-only
oid = “1.3.6.1.2.1.11.5.0”
snmpInBadCommunityUses: The total number of SNMP messages delivered to the
SNMP protocol switch and representing an SNMP operation that was not allowed by the
SNMP community named in the message
Access: read-only
oid = “1.3.6.1.2.1.11.6.0”
snmpInASNParseErrs: The total number of ASN.1 or BER errors encountered by the
SNMP protocol switch when decoding received SNMP Messages
Access: read-only
oid = “1.3.6.1.2.1.11.8.0”
snmpInTooBigs: The total number of SNMP PDUs which were delivered to the SNMP
protocol switch and for which the value of the error-status field is ‘tooBig'
Access: read-only