Contemporary Control Systems Compact Managed Switches Software Manual for Web Browser - Manual (Page 56)

TD020851-0MG
56
4.6.2 Traps Log
The Traps Log of Figure 46
reports SNMP traps sent since
the last Cold Start and the
number of seconds that have
passed since the Cold Start
occurred (at time zero).
Figure 46 — Traps Log
4.6.3 Monitor STP Port Status
The screens of Figure 47 (where STP is enabled) or that of Figure 48 (where STP is
disabled) report the STP State, Link Status and Port Speed/Duplex for each port.
These show an 8-port switch. A screen for a 16- or 24-port device would extend the
panel to display the proper number of ports. The significance of the reported
information is discussed on the next page.
Figure 47 — Monitor STP Port Status (STP Enabled) for 8-port Models
Figure 48 — Monitor STP Port Status (STP Disabled) for 8-port Models