Comtech EF Data CDM-570/570L Vipersat - Manual (Page 99)

Chapter 3 - Using the Command Line Interface (CLI) 3-63
Vipersat Configuration
Force Modem to Home State
If at any time it is desired to have a CDM-570/570L return to its Home State,
this command (enter Y) can be executed. The Home State parameter values are
“forced” into the Base Modem configuration so that they match. The Base
Modem parameters will be updated to reflect the configuration that has been set
from this menu.
A warning message is displayed as shown in figure 3-81, requiring the
command to be confirmed before it is executed.
Figure 3-81 Force Modem to Home State warning
STDMA State
This command (enter T) toggles the setting of STDMA in the target CDM-570/
570L’s Home State between Enabled and Disabled. This is the same feature
that is set from the Feature Configuration menu screen shown in figure 3-4.
Transmit Frequency
Enter A at the command prompt to use the dialog shown in figure 3-82 to set the
Transmit Frequency for the target CDM-570/570L’s Home State.
Figure 3-82 Transmit Frequency prompt
Note that this screen dialog example displays the frequency range for the CDM-
570L L-Band modem. For the CDM-570, the range displayed will be either 50
to 90 MHz or 100 to 180 MHz.
Transmit Data Rate
Enter B at the command prompt to use the dialog shown in figure 3-83 to set the
Transmit Data Rate for the target CDM-570/570L’s Home State.