Comtech EF Data CDM-570/570L Vipersat - Manual (Page 34)

Initial Configuration
2-10 Vipersat CDM-570/570L User Guide
Address must be defined also. Otherwise, this route is automatically cre-
ated and can be viewed with the Display command.
4. Enter S at the command prompt in figure 2-7 to save the settings to flash.
Set the Satellite Modem Configuration
1. Enter M from the Main Menu, then enter C from the Satellite Modem
menu to access the Configuration screen.
2. Enter T to access the Tx Configuration screen shown in figure 2-8. Set
the Tx parameters for Frequency, Data Rate, FEC, Code Rate, and
Modulation as specified by the network administrator.
Note: Only Turbo Product Coding is acceptable for FEC when the CDM-570/
570L is running in Vipersat mode.
Figure 2-8 Tx Configuration screen
3. Enter R to access the Rx Configuration screen, and set the Rx parameters
as specified by the network administrator.
4. Save the settings to flash by entering S at the command prompt.
NOTE