Comtech EF Data CDM-570/570L Vipersat - Manual (Page 61)

Chapter 3 - Using the Command Line Interface (CLI) 3-25
Vipersat Configuration
Similarly, the Global Switch Type command can be used to set the switch type
for all or a majority of the Remotes. Enter H at the command prompt.
Figure 3-28 Global Switch Type prompt
Delete Remote
Entering D at the command prompt shown in figure 3-20 brings up the Delete
Remote dialog shown in figure 3-29.
Figure 3-29 Delete Remote prompt
Enter the number of the Remote CDM-570/570L at the command prompt to
delete it from the STDMA group for this Hub burst controller.
Enable/Disable Remote
Enter E at the command prompt in figure 3-20 to display the dialog shown in
figure 3-30. The Remotes in the STDMA group are displayed, indicating
whether each is currently Enabled (E) or Disabled.
Figure 3-30 Enable/Disable Remote prompt
Enter the number of the Remote at the command prompt to toggle the Remote
from its current Enable/Disable configuration.
In the example screen shown above, Remotes 1 and 2 are Enabled and Remotes
3 and 4 are Disabled.
View Remote(s)
Entering V at the command prompt shown in figure 3-20 will display the listing
of Remote(s) that belong to the STDMA group for this Hub burst controller, and
their status, as shown in figure 3-31.