Comtech EF Data CDM-570/570L Vipersat - Manual (Page 90)

Vipersat Configuration
3-54 Vipersat CDM-570/570L User Guide
If the FAST feature key for Management Security has been purchased for the
target modem, then it will appear as a menu item on the Vipersat Configuration
screen (figure 3-6).
Enter K at the command prompt to configure this feature, as shown in
figure 3-72, below.
Figure 3-72 Vipersat Management Security screen
Enter M at the command prompt to toggle between Enabled/Disabled.
Note that the feature must be set to Enabled in order to configure the encryption
key.
Enter K at the command prompt and Enter the required key (figure 3-73).
(Following entry, the characters will be temporarily displayed in the menu for
reference purposes.)
Figure 3-73 Encryption Key Entry prompt
Enter V at the command prompt and re-enter the same key to Verify it.
(Following entry, the characters will be temporarily displayed in the menu for
reference purposes.)
Enter G at the command prompt to execute the verification process and Gener-
ate the hex key.
The Future Key menu item will display Valid to indicate successful verification
of the key and that it is ready for activation.
Enter A at the command prompt to Activate the key for current use.
The Current Key menu item will display Valid to indicate successful activation.