Comtech EF Data CDM-570/570L Vipersat - Manual (Page 42)

Menu Descriptions
3-6 Vipersat CDM-570/570L User Guide
Figure 3-5 FAST Feature Code dialog
Tip: Contact either the network administrator or Comtech Vipersat Networks
Customer Support to obtain the FAST Feature code. A convenient option
is to use the Vipersat Vload utility to manage Feature codes.
Vipersat Management
This item is an information only display and indicates whether Vipersat
Management is enabled or disabled in the target Vipersat CDM-570/570L.
Activation of the Vipersat Feature Code automatically enables the Vipersat
Management feature.
Caution: This command must be Enabled in order to utilize any of the Vipersat
capabilities of the CDM-570/570L.
Vipersat STDMA
In order to utilize the Vipersat STDMA feature (burst mode) in the target
Vipersat CDM-570/570L, this feature must be Enabled. Enter A at the
command prompt to toggle On or Off.
Refer to table 2-2 for the relationship between Unit Role and STDMA. For a
Hub STDMA Burst Controller or a Remote STDMA modem, this feature must
be Enabled. For a private point-to-point SCPC modem, Hub or Remote, this
feature must be Disabled.
Vipersat Auto Switching
The Vipersat Auto Switching feature allows the CDM-570/570L to automati-
cally adjust to varying bandwidth demands in the Vipersat network by switch-
ing between STDMA and SCPC connections for Load, Application, ToS, and
QoS. Auto switching must be Enabled on a CDM-570/570L if that modem will
be sending any switch requests to the VMS. Refer to table 2-2 for the relation-
ship between Unit Role and Auto Switching.
To activate the Vipersat Auto Switching capabilities of the target CDM-570/
570L, toggle the Auto Switching command to Enabled by entering W at the
command prompt.