Comtech EF Data CDM-570/570L Vipersat - Manual (Page 31)

Chapter 2 - Quick Start Configuration 2-7
Initial Configuration
Figure 2-6 Ethernet Interface screen
2. Enter I at the command prompt, and enter the designated IP address for
this unit.
3. Save the settings to flash by entering S at the command prompt.
Configure the Route Table
Routing in a Vipersat Network
CDM-570/570L Modem Routers operating in Vipersat mode do not use the
small or large network described in the CDM-570/570L Installation and Opera-
tion Manual. There is no HDLC address in a Vipersat network; instead, the
CDM-570/570L role designation — Hub or Remote, Expansion unit or not —
determines routing rules that prevent multicast loops. This simplifies the config-
uration of a Vipersat network.
Because satellite networks are often used as extensions for access to services
such as the Internet or the PSTN, they lend themselves quite readily to private
addressing. For example, to provide Internet access to the satellite network, only
the Hub requires a public IP address in order for the entire satellite network that
is controlled by the Hub to have access to the Internet backbone. Utilizing
Network Address Translation (NAT), the administrator can effectively address
the network using a minimum number of static route statements.
Example:
The IP address 172.16.0.0 is the private address network number for class B
networks. If there is a router at the Hub with a connection to the Internet, the
operator can define the local network as a class B. If the operator splits the