Comtech EF Data CDM-570/570L Vipersat - Manual (Page 33)

Chapter 2 - Quick Start Configuration 2-9
Initial Configuration
Figure 2-7 Configuring the Route Table screen
In a Hub configuration, the default route will typically point to a router on the
same LAN as the CDM-570/570L Hub unit.
In a Remote configuration, the default route will typically point to the satellite
modem used for communications back to the Hub.
3. When prompted, enter the Route Name (GW), the IP Address, the
Number of Bits in the subnet mask, the Route Interface (Ethernet or Sat-
ellite), and the Next Hop address. The system administrator can supply
this information, if necessary.
In a Hub role, for example, enter the name of the route (e.g., DFG), enter
0.0.0.0 for the destination IP address and 0 for the mask, enter E for
Ethernet interface, then enter the IP address of the appropriate router or
modem for the next hop.
If this Hub unit is providing the TDM outbound, a route statement or state-
ments defining satellite communications with the Remote units must be
entered as well. One recommended option is to enter a single super-route
that will handle satellite communications with all of the remote subnets; an
example of this is shown as Route002 in figure 2-7, above.
If there are multiple burst controllers at the Hub and they are not using the
same default address (239.1.2.3), then a route with the Burstmap Multicast