Comtech EF Data CDM-570/570L Vipersat - Manual (Page 106)

Vipersat Configuration
3-70 Vipersat CDM-570/570L User Guide
Caution: This command affects all communications for the VMS and STDMA.
If the base address is changed, it must be changed in the VMS as
well as in all modems in all networks controlled by the VMS. The base
address must also be changed when using VLOAD with this network.
Alerts
The Alerts menu item in the Vipersat Configuration screen is for information
only and serves to display alert messages to the operator.
• Example: “ Critical error: should not be in map ”
This alert typically occurs when there are multiple STDMA burst
controllers at the Hub incorrectly configured with the same Group ID, thus
causing Remotes to appear in more than one burstmap. A Remote may
already be switched out into dSCPC mode, yet continue to appear in a
burstmap that is received from another controller.