Comtech EF Data CDM-570/570L Vipersat - Manual (Page 41)

Chapter 3 - Using the Command Line Interface (CLI) 3-5
Menu Descriptions
Feature Configuration
The Feature Configuration screen shown in figure 3-4 allows the Enabling
and Disabling of the major Vipersat CDM-570/570L features.
Figure 3-4 Feature Configuration screen
Use this menu to enable and disable Vipersat features such as:
• Vipersat STDMA — Burst mode operation
• Vipersat Auto Switching — Allows switching to SCPC mode
• Vipersat File Streamer — Rapid file transfers over satellite network
Note: These Vipersat features must be enabled or disabled using this menu.
They cannot be enabled or disabled from the Vipersat Configuration
screen.
Vipersat Feature Codes
From the Feature Configuration menu, verify whether or not the Vipersat
Feature Codes are Available (appears as shown in figure 3-4). These codes are
entered prior to shipment from the factory; however, if the codes display as
Unavailable, they will have to be re-entered. To enter the FAST Feature code,
enter Y at the command prompt.
The Vipersat FAST Feature Code can be entered as 20 hexidecimal digits at the
command prompt as shown in figure 3-5.
NOTE