Cloud Electronics DCM1 - Manual (Page 71)

DCM1 & DCM1e Installation and User Guide v1.0 71
Factory default settings – menu
options
The table below lists the default factory settings for all
DCM1 menu options. These are the settings which the unit
will assume on power-up if Power Up Mode is set to
Factory
.
The factory default key for enabling Installer Mode is included
in the list at System Mode > Set Key.
MUSIC MENU:
Select Input
Input 1 routed to all Zones; no other
assignments
Level All Zones at minimum (muted)
Treble 0 dB
Mid 0 dB
Bass 0 dB
Input Gain All Inputs 0 dB
Maximum Music Level All Zones 0 dB (max.)
Minimum Music Level All Zones -62 dB (muted, min.)
ROUTING MENU:
Enable Mic Inputs No Mics assigned to any Zone
Input Enable All Inputs available in all Zones
Configure Access Connector Input
CDPM Zone Offset 0
CDR Zone Offset 0
SYSTEM MENU:
CDR Zone Setup All Zones OFF
Stereo/Mono Zone Selection Zones 1 and 2 stereo
Rename Inputs Input 1 to Input 8
Rename Zones Zone 1 to 8
Rename Groups Groups 1 to 4
Set Key 1234
RS232 Baud Rate 9600
RS232 Flow Control OFF
Power Up Mode Factory
Save Defaults n/a
Update Firmware OFF
Reset Mixer n/a
PRIORITIES MENU:
Select Priority Line Input No Input assigned to any Zone
Line Priority Hold Time 3 sec.
Line Priority Release Time 1 sec.
Set Mic Priority Input No Input assigned to any Zone.
Mic Priority Hold Time 3 sec.
Mic Priority Release Time 1 sec.
Mic Priority Attenuation 30 dB
Page Priority Select Off
Page Priority Hold Time 3 secs.
Page Priority Release Time 1 sec.
Page Priority Attenuation 30 dB
Select Emergency Source No Input assigned
Emergency Level Maximum
Configure Music Mute Normally Open (N/O)
GROUPS MENU:
Group Enable No Groups enabled
Group Member No Groups defined
Note that restoring the factory default settings (either by
setting Power Up Mode to Factory, or by moving
jumper J9) does not overwrite any Input, Zone or Group
names that have been assigned.
Factory default settings – network
settings
The following network settings are applicable to the DCM1e
only:
Network Item Setting
IP Address DHCP enabled
NETBIOS Name DCM1-ANON
MAC Address
00:04:A3:xx:xx:xx
00:1E:C0:xx:xx:xx