Cloud Electronics DCM1 - Manual (Page 22)

DCM1 & DCM1e Installation and User Guide V1.0 22
Mic and Line Input Modules
Remote input modules from the Cloud ME-1, LE-1 and BE-1
ranges may be connected to the DCM1 in a similar manner
to that described for the CDR-1 remote controls, except that
screened
Cat 5 cable should be used.
Remote modules may be “daisy-chained” for wiring
convenience, providing that the following guidelines are
observed:
•
ME-1 mic input modules cannot co-exist on the same
“daisy-chain” as LE-1 line input modules or BE-1
balanced input modules.
•
LE-1 and BE-1 modules can co-exist on the same “daisy-
chain”.
•
If more than one module is used for remote inputs
simultaneously, a mixed sum of all sources will be
presented to the DCM1 input.
Note that the two mic inputs on the ME-1 and ME-1A remote
modules are summed together and passed to the DCM1 as a
mono signal. The ME-1M has a single mic input.
The two inputs on all versions of the LE-1 and BE-1 are
intended for stereo use, and these modules’ connections to
the DCM1 maintain the stereo image of the source.
The diagram below illustrates some of the connection
possibilities. Three ME-1, two LE-1 and one BE-1 modules are
shown.
MICROPHONE INPUTS 1 & 3 and EXTENSION
PORTS 3 & 4 are chosen for reasons of drawing clarity; any
could be used in practice.
LINK IN
OUT
OUT
MICROPHONE INPUTS
1
2
3
4
EXTENSION PORTS
1
2
3
4
OUT
DCM1
OUT
LINK IN
OUT
OUT
BALANCED MUSIC INPUT
LEFT
INPUT
RIGH T
INPUT
PEAK
MUSIC INPUT
TRI M
-12 +12 dB
LINE LEVEL
R
L
HEADPHONE LEVEL
INPUTS
PEAK
MUSIC INPUT
TRI M
-12 +12 dB
LINE
LEVEL
R
L
HEADPHONE LEVEL
INPUTS
ME-1
ME-1
ME-1
LE-1
LE-1
BE-1
MICROPHONE INPUT
LEVEL + LF HF + + LF HF +
OFF
10
MIC 1
LEVEL
OFF
10
MIC 2
MICROPHONE INPUT
LEVEL + LF HF + + LF HF +
OFF
10
MIC 1
LEVEL
OFF
10
MIC 2
MICROPHONE INPUT
LEVEL
+ LF HF + + LF HF +
OFF
10
MIC 1
LEVEL
OFF
10
MIC 2