BSS Audio FDS-334T Owner's Manual - Manual (Page 35)

3 5
There are six output sections on a FDS-336T; Output 1 through Output 6, and four on a FDS-
334T.
The Output parameter screens are accessed by pushing the Output trim knob on the front panel
next to the Output channel that is to be edited.
Stereo Linked Outputs
When the unit is Stereo Linked, combinations of Outputs are linked so that when changing
parameters such as EQ or Crossover settings, both channels change together.
In 2 channel 3 way configuration, Output 1 and 2 parameters, Output 3 and 4 parameters and
Output 5 and 6 parameters are ganged in pairs.
In LCR 2 way configuration Outputs 1, 3 and 5 are linked as are 2, 4 and 6.
When Outputs are linked, the band name is derived from the channel assigned to the lower
numbered Output. Similarly, if the linked Outputs are offset, the parameter value for the lower
numbered Output is displayed. To see the values set for the higher numbered Output turn
Stereo Link off.
Outputs Name
Output Name
The Output ‘band’ name is selectable from a pre-programmed list. Use the < and > navipad
keys or encoder to scroll through the list. Choose a name that most appropriately describes the
usage for each channel. Available names:
Bands 1-6 (FDS-336T)
L Low, L Mid, L High
R Low, R Mid, R High
C Low, C Mid, C High
Subs, Low, Low Mid, Mid, Hi Mid, High
Mid+High
1” Horn, 1.5” Horn, 2” Horn
Bullet
Flat
Unused
Bar, BStage
Delay
Centre
Mono
Aux
10”, 12”, 15”, 18”, 21”, 24”
Delay 1-6
L Subs, C Subs, R Subs
Outputs