Software (dde applications), Baud rate setup, 3 software (dde applications) – Bronkhorst EL-FLOW Prestige User Manual
Page 19: 4 baud rate setup
Bronkhorst High-Tech B.V.
EL-FLOW Prestige
19
9.17.084
3.4.3
Software (DDE applications)
Examples of free Bronkhorst DDE client applications: FlowDDE, FlowPlot and FlowView. Other software programs supporting DDE
are for example MS-Office, LabVIEW, InTouch and Wizcon.
Bronkhorst® software applications 'FlowView' (left) and 'FlowPlot' (right)
i
www
FlowDDE and other Bronkhorst applications are available on the support CD or can be downloaded from the
Bronkhorst internet site:
3.4.4
Baud rate setup
EL-FLOW Prestige instruments support the following baud rates for RS232 communication. The factory selected baud rate is
indicated on the instrument back-side label. Refer to section 4.3.2 for changing the baud rate settings for the instrument. The
default baud rate for RS232 communication is 38400 Baud.
Mode:
Digital
Interface/medium:
RS232
Protocol:
FLOW-BUS (Propar)
Baud rate:
9600
16200
38400
57600
115200
230400
460800
Node address:
3
Parity:
None
RS232 communication options
Changing RS232 settings of the 9-pin sub-D side connector interface
Refer to section 4.3.2 for changing the baud rate settings for the instrument.
Make sure that the instrument’s baud rate corresponds with the baud rate of the application the instrument is
communicating with, otherwise no communication can be established.
For RS232 communication, the maximum cable length is 10 m for baud rates up to 38400 Baud. For higher baud
rates, use cable lengths of maximum 3 m.
i
www
For more information regarding communication through an RS232 interface, see document 9.17.027: RS232
interface with FLOW-BUS for digital instruments.