Bronkhorst BRIGHT (V2.00 and higher) User Manual
Instruction manual, Bright local colour tft readout and control module
instruction manual
BRIGHT
Local colour TFT readout
and control module
Doc nr.: 9.17.048F Date: 08-05-2014
ATTENTION:
Before installing and operating the instrument it is recommended to read the Short-form user manual or this
instruction manual. Not following the guidelines could result in personal injury and/or damage to the equipment.
Table of contents
Document Outline
- 1 Scope of this manual
- 2 Unpacking
- 3 Mounting
- 4 Connecting
- 5 User Interface
- 5.1 Buttons
- 5.2 Power-up
- 5.3 Display
- 5.4 Measure readout
- 5.5 Custom readout 1
- 5.6 Custom readout 2
- 5.7 Top line
- The top line will show the USERTAG or the serial number of the connected instrument.
- 5.8 Edit Setpoint
- 5.9 Reset Counter
- 5.10 Reset Alarm
- 5.11 Select Instrument
- 6.1 Readout screen
- 6.2 readout format
- 6.3 fluidset selection
- 6.4 fluid capacity
- 6.5 Controller settings screen
- 6.6 Setpoint slope
- 6.7 Controller mode
- 6.8 Master slave settings
- 6.9 PID controller settings
- 6.10 Controller response settings
- 6.11 Counter settings screen
- 6.12 Set counter mode
- 6.13 Set counter parameters
- 6.14 Set setpoint at counter limit
- 6.15 Alarm settings screen
- 6.16 Set alarm mode
- 6.17 Set alarm mode parameters
- 6.18 Set setpoint at alarm
- 6.19 Setup menu
- 6.20 Get instrument information
- 6.21 Change usertag
- 6.22 Customize display info
- 6.23 Display appearance
- 6.24 Bus settings
- 6.25 Advanced menu
- 6.26 Sensor filter settings
- 6.27 Sensor auto zero
- 6.28 Restore instrument settings
- 7.1 Security modes
- 7.2 Enter the security settings screen
- 7.3 Security items
- 7.4 Change Password
- 7.5 Reset Password
- 6 Settings menu
- 7 Security Settings
- 8 Troubleshooting
- 9 Technical Data
- 10 Service