Besa Lighting Karli (Mini Pendants 12V) - Manual (Page 6)

All electrical connections and the installation of this fixture must be in agreement with local codes,
ordinances or the NEC (National Electric Code) or CEC (Canadian Electrical Code).
Do not connect this fixture to an electrical system that does not provide a means for equipment grounding.
GLASS SHADE INSTALLATION GUIDE
6695 Taylor Rd. Blacklick, OH 43004
www.besalighting.com
Relamp with a low-pressure type lamp,
either xenon or halogen. Packaging of
this lamp will typically indicate that it’s
“Suitable For Use in an Open Fixture”
or marked with the symbol shown.
IMPORTANT: The pendant and glass assembly you have received is designed such that the glass
must be installed prior to hanging the pendant.
1. Begin by threading the Treaded Nipple into the top of the Socket Assembly and secure using the Lower
Hex Nut and Washer provided. Then secure the Washer between the two Upper Hex Nuts provided.
See figure 1.
2. Following figure 2, the glass shade (shape may vary) will be positioned as shown. Lower the glass
shade until it rests on the Washer. Depending on the thickness of glass, the Upper Hex Nuts and
Washer may require adjustment to allow the Decorative Cap to properly seat at top the glass shade.
For lamping, plug the provided 50W Lamp provided. For relamping never exceed 50 watts,
as greater wattages could cause overheating, adversely affecting the life of the luminaire.
While performing the remaining instruction steps, care must be taken to keep
the glass shade and assembly protected, otherwise breakage may occur.
Lower Hex Nut
and Washer
Socket
Assembly
Figure 1
Figure 2
Lamp
Washer
Decorative Cap
Threaded
Nipple
Upper Hex Nuts
Use With
these Models:
• Karli
(7198xx)