Beisler 2211-5 - Manual (Page 93)

- D 93 -
Short Seam Automat 2211-5 Working Instructions Beisler Automated Sewing Equipment
D.3
Programming
D.3.11 Level 4 special parameters / Functions
Level 4 submenus
%X , EFG7+
F1 Back to level 3
F2 Enable/disable vacuum
F4 Enable/disable working plate cutter (left trousers
component)
F5 Enable/disable working plate cutter (right trousers
component)
F6 Enable/disable pick-up plate front cutter (left slash
selvage)
F7 Sewing to fixed end-of-seam position
F8 Request next level (level 5)
„ „ „ „ „ Enabling or disabling vacuum:
The vacuum is used as a fixing aid for the left or right trou-
sers component before the clamp transport transfer. It can
be disabled during the checking of machine movements.
To enable or disable this function:
X
• Press key.
NOTE - Operation without vacuum!
During normal production operation, the vacuum
should always be enabled as otherwise failures in the
machine cycle may occur.
„ „ „ „ „ Enabling or disabling cutters:
Sewing programs have been programmed at the factory
with an individual cutter cut. For specific seams, this func-
tion can be enabled or disabled separately:
1. Working plate cutter (left trousers component).
E
• Press key.
2. Working plate cutter (right trousers component).
F
• Press key.
3. Pick-up plate cutter (left slash selvage, right side po-
cket, left slash selvage for ladies' trousers).
G
• Press key.
„ „ „ „ „ Sewing to fixed end-of-seam position:
If this function is enabled, a fixed position for the end of
the seam can be programmed for sewing the slash sel-
vages:
7
• Press key.