Beisler 2211-5 - Manual (Page 34)

Short Seam Automat 2211-5 Working Instructions
- B 34 -
Beisler Automated Sewing Equipment
Controlling machine cycle in Mode 05:
1. Line up left slash selvage.
2. Depress left footswitch for slash selvage clamp:
• The slash selvage clamp closes.
3. Depress footswitch for machine operation:
• The folder moves right to the pick-up plate.
• The cutter "Slash selvage" cuts.
• The slash selvage is crimped over and picked up.
4. Depress footswitch for machine operation and keep
depressed:
• The cutter "Left trousers component" opens, vacu-
um is activated.
• Line up and smooth out left trousers component.
5. Release footswitch:
• The cutter "Left trousers component" cuts.
• The folder puts the slash selvage down onto the
left trousers component.
6. Depress footswitch for machine operation:
• The main clamp moves to the insertion station and
picks up the sewing pieces.
7. Depress footswitch for machine operation:
• Further machine cycle is fully automatic:
The folder moves right.
The main clamp transports the sewing pieces to
the sewing head.
The sewing pieces are tucked and blown off from
the working plate with compressed air.
The main clamp returns to its start position.
The next machine cycle starts.
NOTE - Supplying sewing pieces!
If the fully automatic machine cycle was started, the next
sewing pieces can be lined up.
The footswitch for machine operation remains deactiva-
ted until the main clamp reaches its start position; after that,
the next machine cycle can be started.
B.3
Operation
B.3.11 Start mode 04 / 05
Start mode for:
•
"Left slash selvage"
• "Left and right side pocket"
• "Right slash selvage for ladies' trousers"
The machine cycle "Crimping over left slash selvage and
sewing to left trousers component" can be performed in
two different modes (Mode 04, Mode 05).
Controlling machine cycle in Mode 04:
1. Line up left slash selvage.
2. Depress left footswitch for slash selvage clamp:
• The slash selvage clamp closes.
3. Depress footswitch for machine operation:
• The folder moves right to the pick-up plate.
• The cutter "Slash selvage" cuts.
• The slash selvage is crimped over and picked up.
4. Depress footswitch for machine operation and keep
depressed:
• The rear cutter "Left trousers component" opens,
vacuum is activated.
• Line up and smooth out left trousers component.
5. Release footswitch:
• Further machine cycle is fully automatic:
• The cutter "Left trousers component" cuts.
The folder puts the slash selvage down onto the
left trousers component.
• The main clamp picks up the sewing piece.
• The main clamp transports the sewing pieces to
the sewing head.
• The sewing pieces are tucked and blown off from
the working plate with compressed air.
• The main clamp returns to its start position.
6. The next machine cycle starts.
NOTE - Supplying sewing pieces!
If the fully automatic machine cycle was started, the next
sewing pieces can be lined up.
The footswitch for machine operation remains deactiva-
ted until the main clamp reaches its start position; after that,
the next machine cycle can be started.