Beisler 2211-5 - Manual (Page 29)

- B 29 -
Short Seam Automat 2211-5 Working Instructions Beisler Automated Sewing Equipment
Fig. 22/23
Fig. 22
Fig. 23
Fig. 23: Display during seam number selection:
1 Active seam number
2 Passive seam number
3 Seam number is selected
B.3
Operation
B.3.3 Selecting the sewing program
After the machine has been turned on and the control pro-
gram has been activated, the sewing program that had
been selected last is set.
Sewing programs are stored in the memory (M) where up
to 50 sewing programs (M 01 -
M 50) can be pro-
grammed.
To each sewing program, up to six seam numbers (01, 02,
03, 04, 05, 06) are assigned.
Fig. 22: The program control of the machine is program-
med at the factory with a sewing program 1 with three
different seams 2.
The name of the sewing program is M 01, the seams are
marked by the seam numbers (01, 02, 03):
•
Seam 01 is used for clipping and crimping over the left
slash selvage and for sewing the left slash selvage to
the left trousers component.
• Seam 02 is used for sewing the right slash selvage to
the right trouser component.
• Seam 03 is a test seam that is restricted to two func-
tions:
• Clamp movement from the insertion station to the
sewing head,
• Starting/ending the complete sewing process.
The test seam is used for checking the clamp trans-
port and the sewing process when the machine is set
up.
1. Select sewing program at operating panel.
Request memory:
• Press key.
Select sewing program number, e.g. 01:
• Press and
keys.
The selected program is activated immediately.
2. Select seam number of desired seam.
Move cursor to seam number:
• Press . or Y key.
Confirm selection:
• Press $ key.