Beisler 2211-5 - Manual (Page 79)

- D 79 -
Short Seam Automat 2211-5 Working Instructions Beisler Automated Sewing Equipment
D.3.1 System menu
„ „ „ „ „ Running clamp motor in permanent test
The clamp motor can be run permanently to check for
constant machine movement.
• Press W key.
• Press key (diagnostics).
• Press key (clamp transport).
• Press key (clamp motor permanent test).
Confirm safety prompt.
Press $ key.
The clamp motor runs permanently until it is stopped. To
stop the motor:
• Press key STOP.
„ „ „ „ „ Testing the thread cutter
By entering a three-digit value global parameter 35, you
can determine when the thread cutter is activated. The
input must be checked for a machine cycle and corrected
if required.
• Press W key.
• Press key (diagnostics).
• Press key (sewing motor).
• Press key (thread cutter).
• Enter value using numeric keypad.
Start or stop machine cycle.
• Press key.
D.3
Programming
D.3.1 System menu
„ „ „ „ „ Copying variables to the memory stick
All variables (global parameters/special parameters) can
be stored on the memory stick (backup copies).
• Insert memory stick into USB slot.
• Press W key.
• Press key (init parameters).
• Pess Machine <--> Stick.
• Press key Machine memory--> Stick.
Confirm safety prompt.
• Press $ key.
„ „ „ „ „ Loading variables from the memory stick
All variables (global parameters/special parameters) can
be downloaded from the memory stick to the program con-
trol memory to reestablish the machine configuration.
• Insert memory stick into USB slot.
• Press W key.
• Press key (init parameters).
• Pess Machine <--> Stick.
• Press key Stick --> Machine memory.
Confirm safety prompt.
• Press $ key.
NOTE - Current configuration!
If this function is used to download all variables from
the memory stick to the program control, all current
sewing programs will be overwritten.