Beisler 2211-5 - Manual (Page 49)

- C 49 -
Short Seam Automat 2211-5 Working Instructions Beisler Automated Sewing Equipment
C.5
Maintenance
C.5.4 Repairs
Clamp rail replacement:
The clamp rail must be replaced if the protective lining at
the bottom side of the rail is worn.
Clamp rail removal:
1. Fig. 9: Lift main clamp 1.
2. Loosen retaining screw 2.
3. Pull clamp rail 1 down and remove.
Clamp rail installation:
1. Insert clamp rail 1 into fixture and push up until it has
reached the stop. Make sure the clamp rail is positioned
evenly in the fixture.
2. Tighten retaining screw 2.
Cutter replacement:
The cutters are integral to a block together with the pres-
sure cylinder. The cutter block for the left slash selvage
is attached with two fixing angles 1 and 2 and screws
to the pick-up plate bracket.
The two cutter blocks for the left and right trousers com-
ponents are each attached with a fixing angle 3 and
screws to the bottom of the working plate.
Cutter block replacement:
1. Disconnect compressed air hoses (the hoses are
merely pushed onto the sleeve).
2. Fig. 10: Remove retaining screws 4.
3. Position new cutter block, secure using screws and
connect compressed air hoses.
4. Readjust cutter position as described in Section 5.5,
"Machine set-up".
Fig. 10
Fig. 9/10
Fig. 9