Beisler 2211-5 - Manual (Page 48)

- C 48 -
Short Seam Automat 2211-5 Working Instructions Beisler Automated Sewing Equipment
C.5
Maintenance
C.5.4 Repairs
Clamp transport belt replacement:
1. Disconnect machine from power supply system.
2. Slide clamp to left until it reaches stop position.
3. Fig. 7: Remove retaining screws 3 from drive roller
cover 2 and remove cover.
4. Remove two retaining screws from slide roller cover
8 and remove cover 9.
5. Loosen two belt lock screws 4 and release belt ten-
sion 7.
6. Loosen lock nuts 6 of set screws 5 and rotate two
set screws backward.
7. Fig. 8: Remove two connecting screws 1 from main
clamp pedestal. Remove belt.
8. Fig. 7: Install new belt to drive roller 1 and to guide
roller a.
9. Fig. 8: The ends of the belt 3 are fitted with holes.
Position the two ends of the belt with the belt clamp 2
exactly over the holes on the pedestal 4 and secu-
re them using screws.
10.Fig. 7: Tension belt by tightening two set screws 5
until the belt can be depressed approx 10 mm with di-
stinct counterpressure at the middle of the transport rail.
Tighten lock nuts 6 and lock screws 4.
11. Install the two covers 2 and 9
Fig. 7
Fig. 7/8
Fig. 8
.