Beisler 2211-5 - Manual (Page 74)

Short Seam Automat 2211-5 Working Instructions
- D 74 -
Beisler Automated Sewing Equipment
D.2
Fundamentals of programming
D.2.1 Program control layout
Access to menus
The following menus are freely accessible:
•
Service menu,
• Global parameter menu,
• Special parameter menu.
Except for three submenu pages, the entire system menu
is controlled by access privileges. These privileges pro-
tect the system menu from unauthorized access. Data
cannot be entered and the system menu cannot be mo-
dified unless the service code is entered. This code is
contained in the documentation delivered with the machi-
ne.
Menu level structure
Fig 2: The program control is divided into six menu levels
(start level and levels 1-5).
The system menu is requested from the start level. The
remaining operator prompting is achieved with plain text
in the submenus.
The service menus are requested directly from the start
level and from level 1.
The global parameter menu is requested from level 1,
the parameters pertaining to the menu are selected and
changed in a list.
The special parameter menu is requested from level 1
and edited in four other levels (levels 2-5) and in the per-
taining parameter lists.
CAUTION - Damage to machine!
Some of the menu entries start machine units or a
machine cycle.
This may damage machine components if the machine
is not ready for operation.
Do not enter data unless the machine is ready for
operation.
Factory setting
The program control of the machine is programmed at the
factory with a sewing program with three different seams.
Factory settings
The machine comes with a factory-installed standard pro-
gram M 01 with three seams (01, 02, 03) and M02 with
two seams (11, 12).
The seams of M01 differ in their control functions by se-
wing pocket edge and pocket bag:
•
Seam 01: Clipping and crimping over of the left slash
selvage with subsequent sewing of the slash selvage
to the left trousers component.
• Seam 02: Sewing the slash selvage to the right trou-
sers component.
• Seam 03: Test seam that is restricted to two functions:
• Clamp movement from the insertion station to the
sewing head,
• Starting/ending the complete sewing process.
The test seam is used for checking the clamp trans-
port and the sewing process when the machine is set
up.
The standard program M 02 works with the two seams (11
and 12).
•
Seam 11: Controls the procedure for sewing the side
pocket to the right trousers component.
• Seam 12: Controls the procedure for sewing the side
pocket to the left trousers component.
The standard program M 03 works with the two seams (19
and 20).
• Seam 19: Controls the procedure for sewing the
right slash selvage to the right trousers compo-
nent at ladies' trousers.
• Seam 20: Controls the procedure for sewing the
left slash selvage to the lefttrousers component at
ladies' trousers.