Beisler 2211-5 - Manual (Page 76)

Short Seam Automat 2211-5 Working Instructions
- D 76 -
Beisler Automated Sewing Equipment
D.3
Programming
D.3.1 System menu
The system menu is divided into several submenus. The
submenus themselves are divided into access-protected
and open submenus. Access is protected by the service
code.
Open submenus
Open submenus are freely accessible from the start menu:
•
Enter service code,
• Clamp motor step test
• Display total piece counter
Access-protected submenus
Access-protected submenus can only be opened after the
service code has been entered:
•
Eprom seam parameters
• Copy seam numbers
• Erase seams
• Enter seam name
• Copy sewing program to memory stick
• Load sewing program from memory stick
• Copy variables (global parameters/special parameters)
to memory stick
• Load variables (global parameters/special parameters)
from memory stick
• Run clamp motor in permanent test
• Test thread cutter
NOTE - System menu control!
The submenus of the system menu are requested and
exited using the same keys. Exceptions from this rule
are indicated by plain text in the corresponding menu.
Request the system menu from the start level:
• Press W key.
Confirm input and exit the system menu:
• Press W key.
NOTE - Submenu levels!
All input for the system menus must be started from
the submenu level (1).
To change to the submenu level (1):
• Press . key.
The submenus of the system menu can be requested
using either the arrow keys or the function keys.
NOTE - RESET!
As a rule, a RESET should be performed in the sys-
tem menu after settings have been changed to reset
the machine to its start position.
• Press key STOP twice
„ „ „ „ „ Entering the service code
Entering the service code allows access to the access-
protected submenus of the system menu.
• Press W key
• Press key (service code).
• Enter service code numbers using the numeric keypad.
The code is: 50190
• Press W key to confirm input.
„ „ „ „ „ Displaying total piece counter
With this counter, the total number of finished pieces can
be displayed. The counter cannot be reset.
• Press W key.
• Press key (additional programs).
• Press key (piece counter).
The number of pieces : 0000000 is displayed.