Beisler 2111-4 - Manual (Page 79)

- D 79 -
Short Seam Automat 2110-4 / 2111-4 Workinging Instructions Beisler Automated Sewing Equipment
D.3
Programming
D.3.5 List of special parameters
Special parameters are values that refer to only one
specific sewing program. Changes of these values affect
only the currently selected sewing program for which the
setting is made.
Special parameters are edited in four different levels (level
2 to level 5).
Special parameters can be functions that may be enab-
led or disabled or parameter values that are set in lists.
&'(6 )@7
Request / exit special parameter menu:
Select sewing program and change from start level to level 1:
• Press
key.
Request special parameter menu:
• Press
( key and request submenu.
Exit menu:
• Press
key.
No. Programmable special parameters in lists (F3)
01
CLAMP POSITION RIGHT:
Clamp position right during piece transfer
02
FOLDER SWING RELEASE oder TILL GUIDE TO WORK POS:
Sewing folder
Input of distance (in mm) after which folder swings right after beginning of insertion,
Default 120 mm
03
INSERT SPEED .........:
Clamp insertion speed
04
CLAMP SPEED ..........:
Clamp transport speed
05
WAITING POSITION:
Waiting position of the clamp behind the end of the seam
06
SEWING SPEED 1 .......:
Sewing speed 1 beginning of seam
07
SEWING SPEED 2 .......:
Sewing speed 2 main seam
08
SEWING SPEED 3 .......:
Sewing speed 3 end of seam
09
DISTANCE SEWING SPEED 1:
Distance for slow sewing (sewing speed 1)
10
DISTANCE SEWING SPEED 3:
Distance for slow sewing at end of seam (sewing speed 3)
12
THREAD MONITOR ON AFTER:
Top thread monitor on (distance in mm after beginning of seam)
13
TOP THREAD MON. FILTER:
Filter for top thread monitor (response delay)
14
BOTTOM THREAD MON. FILTER:
Filter for bottom thread monitor (response delay)
16
TACKING LENGTH SEAM BEG:
Initial bar tack length only for lock stitch
17
TACKING LENGTH SEAM END:
Final bar tack length only for lock stitch