Beisler 2111-4 - Manual (Page 49)

- C 49 -
Short Seam Automat 2110-4 / 2111-4 Working Instructions Beisler Automated Sewing Equipment
Fig. 21
Fig. 21
• Press
thread cutter key
Start or stop machine run:
• Press
key
6. Check position C to see if shaft feather key
2 is flush
with motor housing mark
3.
If required, change values and test thread cutting func-
tion.
7. Start thread cutting and recheck positions.
C.5
Maintenance
C.5.5 Machine set-up
Setting the thread cutter:
The three-digit value input (GP Par. 35) determines when
the thread cutter is activated.
The setting of the thread cutter must be checked during
machine operation and corrected as required.
Chain stitch machine:
•
Rotate sewing head handwheel in direction of machine
rotation until thread lever reaches highest point (pin-
ning position E).
Lockstitch machine:
•
Rotate sewing head handwheel in direction of machine
rotation until needle reaches highest point (pinning po-
sition C).
1. Lock handwheel at position C by depressing pinning
pin of hole to left of handwheel.
2. Fig. 21: Install drive belt
1 so that the shaft feather
key
2 is flush with motor housing mark 3.
3. Unlock handwheel.
4. Call menu Global Parameters:
• Press
key
• Press
GP key
Insert the following values in Global Parameters:
Chain stitch machine:
35: Thread lever in position up
195 INC
36: Switch-on pos. for thread cutting 000 INC
Lockstitch machine:
35: Thread lever in position up
200 INC
36: Switch-on pos. for thread cutting 110 INC
Store value and exit setting level:
• Press
key
5. Start the thread cutting function:
• Press
key
• Press
diagnostics key
• Press sewing motor key